WYLER AG, FAQ frequently asked questions, WYLER AG is the leading manufacturer of inclination measuring instruments, inclination sensors, precision spirit levels and software for inclination measurements

1	LEVELSOFT PRO can we implement our company logo with address in the protocol header?

2	LEVELMETER 2000 / On the Levelmeter 2000 a number of units can not be selected The unit “relative base” (mm/REL; “/REL) can not be selected After a few selected units a message “Error” appears on the display.

3	Can the WYLER AG instruments be used together with the software LabView of National Instruments?

4	What is the difference between an angle and an inclination?

5	Where are the WYLER AG instruments available in Europe and worldwide?

6	How can I get the latest WYLER AG software? Updates?

7	The display of an object measured with WYLER AG Levelsoft shows a convex form whereas the object is supposed to have a concave shape

8	The display on the Clinotronic plus always shows OVER

9	The display on my Clinotronic using the unit mm/m is only about 1/10 of the expected angle

10	What is the allowable zero point deviation of my new spirit level?

11	What type of spirit level is required to measure on a shaft with a diameter of 130mm?

12	Batteries: Where can I get batteries type TR164 / 5,4 Volts for MINILEVEL A10? Where can I get a replacement battery 4924/987 - 4.05 Volts for NIVELTRONIC?

13	How to read actual inclination from precision spirit level?

14	Using the unit [mm/m] for a measurement the shown difference is smaller than in reality?

15	How long do we have to wait prior to measuring? How do we know that the instruments have the same temperature as the object to be measured?

16	What is the difference between „steplength“ and „baselength“?

17	How can the flatness of a circle be measured ?

18	How can the flatness of a partial surface be measured?

19	What is the difference between ZEROTRONIC and BlueLEVEL / MINILEVEL NT?

20	Limits of error in compliance with DIN 2276 Part 2 / Electronic inclination measuring devices

21	Do I really need a Granit-Master to measure accurate squareness with an angular instrument?

22	Will magnetic measuring bases allow more precise measurements?

CLINOTRONIC PLUS (Limits of error)
How must I interpret the tolerance 2 arc. min. + 1 digit?
How much is 1 digit?

CLINOTRONIC PLUS (Resolution)
Which is the resolution of CLINOTRONIC Plus?
What is the meaning of “max. 0.02 mm/m” or “approximately 0.025 mm/m?